probe.h

Go to the documentation of this file.

/*
  probe.h - code pertaining to probing methods
  Part of Grbl
 
  Copyright (c) 2014-2016 Sungeun K. Jeon for Gnea Research LLC
 
  Grbl is free software: you can redistribute it and/or modify
  it under the terms of the GNU General Public License as published by
  the Free Software Foundation, either version 3 of the License, or
  (at your option) any later version.
 
  Grbl is distributed in the hope that it will be useful,
  but WITHOUT ANY WARRANTY; without even the implied warranty of
  MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
  GNU General Public License for more details.
 
  You should have received a copy of the GNU General Public License
  along with Grbl.  If not, see <http://www.gnu.org/licenses/>.
*/
 
#ifndef probe_h
#define probe_h
 
// Values that define the probing state machine.
#define PROBE_OFF     0 // Probing disabled or not in use. (Must be zero.)
#define PROBE_ACTIVE  1 // Actively watching the input pin.
 
// Probe pin initialization routine.
void probe_init();
 
// Called by probe_init() and the mc_probe() routines. Sets up the probe pin invert mask to
// appropriately set the pin logic according to setting for normal-high/normal-low operation
// and the probing cycle modes for toward-workpiece/away-from-workpiece.
void probe_configure_invert_mask(uint8_t is_probe_away);
 
// Returns probe pin state. Triggered = true. Called by gcode parser and probe state monitor.
uint8_t probe_get_state();
 
// Monitors probe pin state and records the system position when detected. Called by the
// stepper ISR per ISR tick.
void probe_state_monitor();
 
#endif